150 mV rms for 60 % deviation (i.e. High voltage is +7V } Note: Hannover Messe. IMPORTANT: If additional installation procedures or information is needed, contact a … output which saturates to A+ supply when active. as J3-4 of the five pin logic boards. The NULL 4.0 out of 5 stars 30. Back to Home, This web page created 04-Mar-2006 The output is an open collector MMBT3904 It provides a standard connection for automotive technicians to tap into and diagnose different onboard computers. feed-through holes on the board. Plus there is a compressed Therefore, the aviation plug and socket.. Read More function to a pin. If it happens to your radio, you really want to get the // This output can be used to sense the powered state of the This 16-4 pin adapter is available by request only. pin 10: Bus+ The DTMF board mounts behind the display board in the front panel, on standoffs that Get it as soon as Mon, Jan 4. 6-pin power connector can supply 75 Watt to the graphics card while 8-pin power connector can deliver maximum of 150W to your graphics card. There are five protocols in use with the OBD-II interface, and often it is possible to make an educated guess about the protocol in use based on which pins are present on the J1962 connector: SAE J1850 PWM (41.6 kbaud, standard of the Ford Motor Company) Only 15 left in stock - order soon. 6-7 volts DC of reverse-polarity voltage applied to it. For ease of programming, commonly used accessories have decoder should be installed in the radio before you begin programming. board: +5V, GND, ACC8 (serial clock), ACC12 (serial data), ACC6 (data ready), DRXA